Our Excellent design 3 -functions- in- ONE Commode chair FW-3331

First of all, thank you very much for choosing Foshan wecare products！

This commode chair is excellent style! It has 3 functions in ONE chair.It can be used as commode chair, shower chair and wheel chair!

Ｉhope you will be interested in it.To let you understand moare abou this chair,please read the instructions carefully before assembling.

The product structure is as follows：

1. Lift Arm Control Switch    2.Backrest    3.Armrest   4.Protective Guard Handle    5.Seat Lid  6.Bucket 7.Detachabel Footrest 8. Plum knob  9.Footplate  10. Triangle Knob   11.PU Pillow  12.PU Pillow adjustment Components 13.Backrest components  14.Seat Cuhion    15.Seat frame Components    16 Subframe Components    17 C-locking button  18 5”wheels set

1- When you open the packing box, please take care to protect all the spare parts in the box.If assembled on the ground, put the paper or carpet on the ground first to prevent scratching. Please pay attention to distinguish the spare parts, and then put them well.Boxes with all spare parts are shown below :1.wheels sets 2. PU Head adjustment Components 3. Protective Guard Handle  4. PU Pillow  5.Detachabel Footrest. Remove the bubble wrap from the spare parts and place them well.

Assembly description:

Step 1: as shown in figure 1 below,insert the backrest components in the tube hole of the seat frame, and force down to the end,then lock the backrest components with the plum knob.

Step 2：The four wheels sets are aligned to the corresponding hole in the tube holes of the subframe and locked with a C-locking button as shown in Figure 2 .

Step 3：Lock the left and right detachable footrests against the front tube hole of the seat frame , as shown in Figure 3.

Step 4：Insert the two protective guard handles into the armrest tubes, allowing the pinball to be aligned with the hole position as shown in Figure 4.

Step 5：The PU pillow adjustment components is inserted into the oval tube of the backrest tube and locked with the triangle knob as shown in figure 5.

Step 6：The PU pillow is inserted into the oval tube of the of the PU pillow adjutment components and locked with the triangle knob as shown in figure 6.

Post-installation inspection:

1- Post-installation inspection:

1) Seat chair installation is correct, please refer to the manual diagram comparison.

2) Verify that all accessories are fully assembled ,please check complete for spare parts.

3) Check the installation for loose phenomenon, if there is loose need to reinstall.

4)  Check the appearance of all components are skewed, you can make appropriate adjustments.

Partial component description :

1)To adjust the pu pillow height and distance, loosen the triangel knob to adjust the distance and then lock it .

2)If you need to wash your hair, you must press the brakes on the 5”wheels to ensure that the chair is fixed and then press down the lift-arm control switch on your back. Adjust the seat angle according to your needs. As shown below: 

3)When entering the seat to sit down, press the left and right sides of the guard tube down the marbles, and then press back into place.

Product maintenance and maintenance methods:

1)Do not scratch or scratch the surface of the product to prevent material damage.

2)Daily cleaning and maintenance with the neutral synthetic detergent, wipe with wet cloth, then wipe with dry cloth.

3.Do not contact with strong acid or alkali to prevent corrosion.

Storage conditions and methods：

The commode chair after packing shall be stored at a temperature of not more than -10°C ~40°C and a relative humidity of not more than 80%. non-corrosive gas, well-ventilated and clean indoor. During transportation should be moisture-proof, avoid light, away from heat sources